UP5-MS/P Pump with Mechanical Seal, PEEK gears 8 l/min
0,00 €
Self-priming electric pumps with compact mechanical seal and helical gears in PEEK. The drive shaft is made of AISI316, with a nickel-plated brass body. The enhanced motor is designed for continuous use under pressure.
Technical details
Part n. (12V / 24V) | 1F405112 / 1F405113 |
Product name | UP5-MS/P |
Voltage | 12V DC / 24V DC |
Max flow rate | 8 l/min (2.1 gpm) |
Max pressure | 6 bar (87 psi) |
Self-priming | 3 m (9.8 ft) |
Max amperage | 16 A (12V) / 8 A (24V) |
Fuse | 20 A (12V) / 10 A (24V) |
Motor power | 200 W |
IP protection | IP67 |
Wire | 1.5 mm² (16 AWG) |
Hose | 13 mm (0.5 in) |
Ports | 3/8" BSPP |
Seal / O-ring | FKM / FKM |
Gears | PEEK, helical |
Shaft | AISI 316 stainless steel |
Body | Nickel-plated brass |
Mechanical seal | Compact mechanical seal |
Weight | 1.6 kg (3.5 lb) |
Dimensions L x W x H | 194 x 103 x 99 mm (7 5/8" x 4" x 3 7/8") |
Standard | ISO 8846 |
Fluids
Allowed:
Water, up to 60 °C
Diesel fuel (minimum flashpoint 38 °C)
Not allowed:
Petrol (gasoline)
Solvents
Flammable liquids with flashpoint below 38 °C
Liquids with viscosity above 20 cSt
Corrosive chemical products
Installation notes
Install a correctly rated fuse (20 A on 12V, 10 A on 24V) and a switch. The warranty expires if no fuse is used.
Use 1.5 mm² (16 AWG) cable, sized to the distance between pump and battery.
Not suitable for switching (PWM) applications because of the built-in EMI filter.
Continuous operation at pressures up to 50% of maximum; higher pressure and current draw only in on/off cycles so the motor can cool down.
Fit the anti-vibration rubber mounts supplied with the pump.
Use an inlet filter, especially with fluids containing impurities, and keep it clean.
Do not run the pump dry for more than a few minutes.
Download
Download Booklet UP5-MS/P 12V (1F405112)
Download Booklet UP5-MS/P 24V (1F405113)
Download Booklet UP5-MS/P 12/24V (1F405215, previous version, max pressure 5 bar)
