UP1-TW Sewage pump rubber impeller 80 l/min
254,00 €
Self-priming electric pump with flexible rubber impeller for waste water and sewage transfer, with a flow rate up to 80 l/min. Technopolymer pump body with a flexible EPDM impeller, reversible, designed for high flow rate. Suitable for fresh water and salt water. Compliant with ISO 8846.
Technical details
Part n. (24V) | 16210213 |
Product name | UP1-TW |
Voltage | 24V DC |
Max flow rate | 80 l/min (21.1 gpm) |
Max pressure | 0.5 bar (7.2 psi) |
Self-priming | 0.5 m (1.6 ft) |
Max amperage | 4.5 A |
Fuse | 7.5 A |
Motor power | 150 W |
IP protection | IP67 |
Wire | 4 mm² (12 AWG) |
Hose | 25 ~ 38 mm (1 ~ 1.5 in) |
Ports | 1 1/2" BSPP |
Seal / O-ring | HNBR / NBR |
Impeller | Flexible rubber impeller |
Weight | 3.6 kg (7.9 lb) |
Dimensions L x W x H | 226.9 x 117 x 97.8 mm (8 7/8" x 4 5/8" x 3 7/8") |
Standard | ISO 8846 |
Fluids
Allowed:
Water (fresh water and salt water), up to 60 °C
Not allowed:
Petrol (gasoline)
Solvents
Flammable liquids with flashpoint below 38 °C
Liquids with viscosity above 20 cSt
Corrosive chemical products
Installation notes
Install a correctly rated fuse (7.5 A) and a switch. The warranty expires if no fuse is used.
Use 4 mm² (12 AWG) cable, sized to the distance between pump and battery.
Not suitable for switching (PWM) applications because of the built-in EMI filter.
Continuous operation at pressures up to 50% of maximum; higher pressure and current draw only in on/off cycles so the motor can cool down.
Use an inlet filter with fluids containing impurities and keep it clean.
Replace the rubber impeller every season or every 500 hours.
Do not run the pump dry for more than a few minutes.
